针刺足三里的脊髓背根神经电信号非线性特征提取

神经系统在外部刺激下会呈现出丰富的放电模式,针刺作为对穴位的机械作用可以等效为对神经系统的一种外部刺激,在针刺刺激下神经系统会产生不规则的电信号.由于神经系统是高度复杂的非线性动力学系统,神经电信号具有很强的非线性,所以本文设计了提插补法、提插泻法、捻转补法、捻转泻法等四种针刺手法的动物实验,获取针刺大鼠足三里穴位的脊髓背根神经束动作电位序列.采用峰峰间期的思想,应用非线性时间序列的方法分析此动作电位序列,通过计算Lyapunov指数、关联维数以及Lempel-Ziv复杂度等参数,提取神经电信号的非线性特征,得到不同针刺手法的神经电信息的编码;并证明了针刺作用下脊髓背根的神经电信号具有明显的混沌特性. 关键词： 针刺 神经电信号 非线性分析 混沌     

Effect of physical disturbance on the structure of needle coke

Through different preparation technology, this paper reports that the needle coke is prepared with coal-tar pitch under the effect of magnetic field and ultrasonic cavitation. It studies the effect of physical disturbance on the structure of needle coke. The structure of needle coke is characterized by scanning electron microscope and x-ray diffractometer, and the influence mechanism is analysed. Results showed that the structure and property of needle coke could be effectively improved by magnetic field and ultrasonic cavitations, such as degree of order, degree of graphitization and crystallization. Comparatively speaking, the effect of magnetic field was greater. The graphitization degree of needle coke prepared under the effect of magnetic field is up to 45.35%.     

利用光学方法研究单针射流等离子体的产生和发展机制

对单针电极射流等离子体产生和发展过程中的光信号进行了研究。首先发现等离子体的长度并不是随外加电压升高而增加,而是和驱动电源的能量在正半周放电脉冲之间的分配有关。通过研究等离子体通道内不同位置的发光信号,发现正半周期第一次放电脉冲是在针尖电极处产生,而第二个脉冲是在等离子体通道中部产生,电子激发温度也是在等离子体中部达到最高。通过分析发现,空间电荷产生的附加电场对于等离子体的产生和发展有着重大影响。     

Optical characterization of atmospheric‐pressure plasma needle

The atmospheric‐pressure plasma needle is a promising source that can be used efficiently for different industrial applications. A radio frequency (RF) (13.56 MHz) generator was used to generate a He–O₂/Ar mixture plasma. The ground‐state oxygen atomic density [O] was calculated as a function of discharge parameters by “actinometry”. The Ar‐I (2p₁ → 1s₂) line at 750 nm and the O‐I (³P → ³S) line at 844 nm were used to estimate the [O] atomic density. The rotational temperature T _R of He–O₂/Ar mixture was measured from the rotational levels of the “first negative system” (FNS) by using the “Boltzmann plot”. The effect of discharge parameters on the atomic oxygen density [O] and the gas temperature was monitored. These results show that [O] density increases with RF power and O₂ concentration, but decreases with the gas flow rate. Whereas the gas temperature increases with increase in the input RF power, it decreases with increase in the gas flow rate and O₂ concentration in the mixture. Since the [O] atomic density contributes to plasma‐based biomedical applications, the proposed optimum conditions for plasma‐based decontamination of heat‐sensitive materials in the present study are 0.6% oxygen, 500 sccm flow rate, and 26 W RF power.     

Modulation of electroencephalograph activities by manual acupuncture stimulation in healthy subjects: An autoregressive spectral analysis

To investigate whether and how manual acupuncture (MA) modulates brain activities, we design an experiment that acupuncture at acupoint ST36 of right leg to obtain electroencephalograph (EEG) signals in healthy subjects. We adopt autoregressive (AR) Burg method to estimate the power spectrum of EEG signals and analyze the relative powers in delta (0 Hz-4 Hz), theta (4 Hz-8 Hz), alpha (8 Hz-13 Hz), and beta (13 Hz-30 Hz) bands. Our results show that MA at ST36 can significantly increase the EEG slow wave relative power (delta band) and reduce the fast wave relative powers (alpha and beta bands), while there are no statistical differences in theta band relative power between different acupuncture states. In order to quantify the ratio of slow to fast wave EEG activity, we compute the power ratio index. It is found that the MA can significantly increase the power ratio index, especially in frontal and central lobes. All the results highlight the modulation of brain activities with MA and may provide potential helps in clinical treatment of acupuncture. The proposed quantitative method of acupuncture signals may be further used to make MA more standardized.     

计算机辅助针灸诊疗专家系统-ZES及其壳体-KZES

本文论述ZES的功能和开发技术。描述了系统中推理的数学模型及其理论基础,最后阐述了ZES的外壳可用作建造中医专家系统的工具。     

Rapid and sensitive methodology for determination of ethyl carbamate in fortified wines using microextraction by packed sorbent and gas chromatography with mass spectrometric detection

This work presents a new methodology to quantify ethyl carbamate (EC) in fortified wines. The presented approach combines the microextraction by packed sorbent (MEPS), using a hand-held automated analytical syringe, with one-dimensional gas chromatography coupled with mass spectrometry detection (GC–MS). The performance of different MEPS sorbent materials was tested, namely SIL, C2, C8, C18, and M1. Also, several extraction solvents and the matrix effect were evaluated. Experimental data showed that C8 and dichloromethane were the best sorbent/solvent pair to extract EC. Concerning solvent and sample volumes optimization used in MEPS extraction an experimental design (DoE) was carried out. The best extraction yield was achieved passing 300 μL of sample and 100 μL of dichloromethane. The method validation was performed using a matrix-matched calibration using both sweet and dry fortified wines, to minimize the matrix effect. The proposed methodology presented good linearity (R² = 0.9999) and high sensitivity, with quite low limits of detection (LOD) and quantification (LOQ), 1.5 μg L⁻¹ and 4.5 μg L⁻¹, respectively. The recoveries varied between 97% and 106%, while the method precision (repeatability and reproducibility) was lower than 7%. The applicability of the methodology was confirmed through the analysis of 16 fortified wines, with values ranging between 7.3 and 206 μg L⁻¹. All chromatograms showed good peak resolution, confirming its selectivity. The developed MEPS/GC–MS methodology arises as an important tool to quantify EC in fortified wines, combining efficiency and effectiveness, with simpler, faster and affordable analytical procedures that provide great sensitivity without using sophisticated and expensive equipment.     

Recent advances in breath analysis to track human health by new enrichment technologies

Detection of biomarkers in exhaled breath has been gaining increasing attention as a tool for diagnosis of specific diseases. However, rapid and accurate quantification of biomarkers associated with specific diseases requires the use of analytical methods capable of fast sampling and preconcentration from breath matrix. In this regard, solid phase microextraction and needle trap technology are becoming increasingly popular in the field of breath analysis due to the unique benefits imparted by such methods, such as the integration of sampling, extraction, and preconcentration in a single step. This review discusses recent advances in breath analysis using these sample preparation techniques, providing a summary of recent developments of analytical methods based on breath volatile organic compounds analysis, including the successful identification of various biomarkers related to human diseases.     

Rapid determination of ethylene oxide with fiber-packed sample preparation needle

Fiber-packed sample preparation device was applied to the simultaneous derivatization/preconcentration of ethylene oxide (EO) in air samples. The polymer-coated filaments were packed longitudinally into the needle, and hydrogen bromide (HBr) was loaded onto the filaments in the preconditioning process. Simultaneous derivatization with HBr in the needle was made during the sampling process of the gaseous EO, and the corresponding derivatized analyte, 2-bromoethanol, was desorbed by passing a small amount of methanol through the extraction needle in the heated gas chromatograph (GC) injector. The basic extraction/desorption parameters for EO have been evaluated. The limit of detection (LOD), limit of quantification (LOQ) and the relative standard deviation (RSD) of run-to-run repeatability were 1.8 ng/L, 5.4 ng/L and less than 4%, respectively, with an extraction time of about 10 min. Satisfactory storage performance for three days at room temperature was also confirmed.     

An interior needle electropolymerized pyrrole-based coating for headspace solid-phase dynamic extraction

A headspace solid-phase dynamic extraction (HS-SPDE) technique was developed by the use of polypyrrole (PPy) sorbent, electropolymerized inside the surface of a needle, as a possible alternative to solid-phase microextraction (SPME). Thermal desorption was subsequently, employed to transfer the extracted analytes into the injection port of a gas chromatography-mass spectrometry (GC-MS). The PPy sorbent including polypyrrole-dodecyl sulfate (PPy-DS) was deposited on the interior surface of a stainless steel needle from the corresponding aqueous electrolyte by applying a constant deposition potential. The homogeneity and the porous surface structure of the coating were examined using the scanning electron microscopy (SEM).The developed method was applied to the trace level extraction of some polycyclic aromatic hydrocarbons (PAHs) from aqueous sample. In order to enhance the extraction efficiency and increase the partition coefficient of analytes, the stainless steel needle was cooled at 5 °C, while the sample solution was kept at 80 °C. Optimization of influential experimental conditions including the voltage of power supply, the time of PPy electrodeposition, the extraction temperature, the ionic strength and the extraction time were also investigated. The detection limits of the method under optimized conditions were in the range of 0.002-0.01 ng mL⁻¹. The relative standard deviations (R.S.D.) at a concentration level of 0.1 ng mL⁻¹ were obtained between 7.54 and 11.4% (n = 6). The calibration curves of PAHs showed linearity in the range of 0.01-10 ng mL⁻¹. The proposed method was successfully applied to the extraction of some selected PAHs from real-life water samples and the relative recoveries were higher than 90% for all the analytes.